DUMB QUESTION: how to safely remove mold from a silicon mask skirt?

[LKunze]

:o OMG. NO i did not clean out my wing of scum. how does one
properly clean that bad boy? <i need a vomit emoticon>

Yikes!!!!!!!! :o
Ok...here's what I do and it works quite well. Unscrew the rear pull dump on the wing and remove it. Then get some warm water and mix in a little Tide "HE" laundry detergent. The "HE" formula is a little more expensive than regular laundry detergent but it doesn't suds up real bad which makes rinsing much easier. Fill the wing up about a quarter to half way and either put the pull dump back on or just plug the opening with your thumb. Then shake the wing around real good. Rinse and repeat as necessary. Once cleaned I leave the pull dump off the wing so it can completely dry out inside.